Sears ER30G Manuale Utente

IR (Infrared) Broil Burner

CAUTION

To prevent damage to the broil burner, do not spray the

burner or its igniter with any type of cleaner or attempt to

scrub them in any manner.

The IR broil burner is self-cleaning. To burn off any

grime build-up, close the oven door and turn the

oven control knob to the BROIL position for about

ten minutes. After ten minutes turn the oven off.

Convection Filter (Oven)

WARNING

The convection filter is made of stainless steel.

•

Remove it only when it is cool.
Re-install the filter before cooking in the oven again.

•

Failure to do so will expose the convection fan blade

that rotates at high speed during convection modes.

Convection Filter Removal and Cleaning

Remove the filter regularly for cleaning. A

•

clogged filter will reduce the effectiveness of

convection cooking. Soak it in hot soapy water.

Dry it completely before re-installing.

To reinstall the filter, orient it so that the mount-

•

ing clips are towards the rear of the oven cham-

ber, open end down. Hook the mounting clips

over the horizontal bar across the opening.

Care and Cleaning

Replacing the Oven Light

WARNING

To prevent an electrical shock hazard and/or personal

•

injury, make sure that power to the range has been

disconnected and that the light fixture is cool before

replacing the light bulb.
Always ensure that the lens cover is in place when

•

using the oven. The lens cover protects the bulb

from breakage caused by high oven temperatures or

mechanical shock.
Replacing the lens cover without lining up the cutout

•

with the light socket will damage the light fixture.
Do not use a screwdriver to remove the lens.

•

Replacing a Light Bulb

Light bulb replacement is considered a homeowner

maintenance operation. If the light does not work,

before replacing it, please consult the Problem

Solution Guide on page 18.

Replace the light bulb only with Dacor part

number 100429. See page 19 for ordering

information. IMPORTANT: Do not touch the

replacement halogen light bulb with your fingers.

Halogen bulbs are sensitive to the oils from your

hand. The oils from your hand will stick to the

bulb and may cause it to burn out faster than

normal.
Disconnect the range power cord from the elec-

trical outlet.
Remove the left rack support. See facing page.

Hold your hand under the lens for support and

gently pry it loose using a spatula or table knife.

Pull the lens

cover straight

out.
Grasp the old

bulb and pull it

straight out of

the socket.
Using a glove,

insert the new

bulb into the

socket.
As you reinstall

the lens cover,

line up the

cutout on the

inside rim with the light socket. Gently press it

into its original position.
Replace the left rack support and reconnect the

power cord.

Clips on back of

filter

Horizontal

bar

Light

fixture

Light

socket

Lens

Lens cutout

Bulb