Siemens C) Manuale Utente

Installation

English 6

For installations other than those in Canada, install the strain relief and connect 
the range cord (or wire conductors) as described in the following steps.

* Varies by location. Refer to local electric code.

•

Tape warming drawer or storage drawer shut to keep it from opening while 
installing the range.

•

During installation, place a portion of the box or a piece of cloth under the 
range to protect floors.

•

To make range lighter and easier to handle, remove door (see instructions in 
Use and Care manual).

We strongly recommend the installation of a ventilation hood above this range. 
For most kitchens a certified hood rating of not less than 300 CFM is recom-
mended. The range hood must be installed according to instructions furnished 
with the hood.

Seal any holes in the walls or floor. Remove any obstructions (extra electrical or 
gas connections, etc.) so that range will rest against wall properly.

Place range in front of cabinets where it is to be installed. Remove any packaging.

The strain relief provided with your range cord must be properly 
installed. 

Place strain relief in knockout below terminal block. See Figure 4: Electrical Con-
nection and Strain Relief Knockout Panel Locations. Feed range cord through 
hole and strain relief up to terminal block. Allow for slack in the cord between the 
strain relief and terminal block. Once cord length/ slack has been adjusted, attach 
strain relief per instructions included with strain relief. 

Tip: 
The knockout panel (below the terminal block) can be removed from 
the range to install the strain relief: Remove panel from range, install 
strain relief in panel and reattach. DO NOT remove entire range back 
panel.

Check data plate for kW rating. Reference kW rating in table to determine 
amperage requirements.

kW Rating

AMPS Required

At 120/240 Volts:

At 120/208 Volts:

US Models:

Canadian Models:

12.3

9.2

40 or 50*

12.6

9.5

40 or 50*

50

13.5

10.2

50