Garmin G1000H Manuale Utente
Garmin G1000H
™
Pilot’s Guide for the Bell 407GX
190-01255-00 Rev. B
356
HAZARD AVOIDANCE
Or
:
a)
Press the MENU Key.
b)
Select ‘‘’Not Available” Mute On’ (shown if TNA muting is currently off) and press the ENT Key.
SYSTEM STATUS
The G1000H performs an automatic test of TIS during power-up. If TIS passes the test, TIS enters Standby
Mode (on the ground) or Operating Mode (in the air). If TIS fails the power up test, an annunciation is shown
in the center of the Traffic Map Page.
in the center of the Traffic Map Page.
Traffic Map Page
Annunciation
Description
NO DATA
Data is not being received from the transponder*
DATA FAILED
Data is being received from the transponder, but a failure is detected in the data stream*
FAILED
The transponder has failed*
UNAVAILABLE
TIS is unavailable or out of range
* Contact a service center or Garmin dealer for corrective action
Table 6-13 TIS Failure Annunciations
Figure 6-90 TIS Power-up Test Failure
Data Not Received
from Transponder
System Test has Failed
The traffic mode is annunciated in the upper left corner of the Traffic Map Page. When the aircraft is on the
ground, TIS automatically enters Standby Mode. If traffic is selected for display on another map while Standby
Mode is selected, the traffic display enabled icon is crossed out (also the case whenever TIS has failed). Once
the aircraft is airborne, TIS switches to Operating Mode and traffic information is displayed. The mode can be
changed manually using softkeys or the page menu.
Mode is selected, the traffic display enabled icon is crossed out (also the case whenever TIS has failed). Once
the aircraft is airborne, TIS switches to Operating Mode and traffic information is displayed. The mode can be
changed manually using softkeys or the page menu.