Lucent Technologies 560-201-113 Manuale Utente

Installing and Configuring the PassageWay
Service Provider

This section applies to users who have an earlier version of the PassageWay
Service Provider or PassageWay Solution installed. If you do not have an
existing version of the PassageWay Service Provider or PassageWay Solution
installed, refer to the previous section, “New PassageWay Service Provider
Users.”

If you have an earlier version of the PassageWay Service Provider software or
PassageWay Solution installed on your PC, perform the following steps:

  1.  Read the section “PassageWay Service Provider Components” to

make sure that you have all of the PassageWay Service Provider
components.

  2.  Read the section “PassageWay Service Provider Requirements” to

make sure that you have the required hardware and software to run
the PassageWay Service Provider.

  3.  Read the section “Before You Begin” to make sure that you have the

necessary information to set up the PassageWay Service Provider.

  4.  Install the PassageWay Service Provider by performing the