Datalogic Scanning QD 2300 Manuale Utente

Setting Up the Scanner

To remove the Interface Cable:

1. Unlatch the installed cable modular connector by depressing the connector clip with the 

end of a paper clip as shown in 

Figure 2

.

2. Carefully slide out the cable.

3. Follow the steps in the previous section, 

Installing the Interface Cable

, to connect a 

new cable.

If the host does not provide power to the scanner, an external power connection to the scanner is 
required. To connect power:

1. Connect the interface cable to the bottom of the scanner, as previously described in the 

section,

Installing the Interface Cable

.

2. Connect the other end of the interface cable to the host (refer to the host manual to locate 

the correct port).

3. Plug the power supply into the power jack on the interface cable. Plug the other end of the 

power supply into an AC outlet.

To configure the scanner, use the bar codes included in this manual.

See 

Chapter 5, General Features

 and 

Chapter 9, Symbologies

 for information about 

programming the scanner using bar code menus. Also see each host-specific chapter to set up a 
connection to a specific host type.

Insert a paperclip

into this hole to

release the

cable latch

Strain Relief

Cable