Cannon Mag 5 Hs Manuale Utente

4 

Side Rail Mounting 
 

 Side/Rail mounts can be mounted to a 

welded T-section. It can also be used at the two 
rail section butt joint. In both installations it is 
recommended to use a non-slip material, such 
as rubber or a thin wood sheet, between metal 
surfaces.  
 
You can also use these for mounting to a very 
narrow side gunwale. There is a plate provided 
for back-up with bolts and washers. If the 
gunwale compartment is foamed in, then 
wellnuts should be used. It is also recommended 
to install two additional flat head screws through 
the top plate for stabilization (you will need to 
drill and countersink).  
 

NOTE: In no case should this mount be used 
on fiberglass ¼" thick or less unless it is 
foamed in. 
Pedestal Mounting 
Pedestals are used wherever additional height is 
needed for ease of operation or to clear 
obstructions, such as handrails. 
 
Caution: When using a pedestal mount 
or side/rail mount, do not extend the 
telescopic boom on your Mag 10 HS \ 
Mag 10 TS.  The increased leverage 
will cause excessive strain and 
possible failure of the mount. 

MOU

N

TIN

G

 & SETUP