AT&T 555-230-894 Manuale Utente
Install and Connect the Cabinets
4-32
Issue 1 September 1995
2. At the upper cabinet, place the top of the ground plate over the bottom of
the lower-back panel so the four screws at the bottom of the lower-back
panel fit through the four ground plate keyhole slots. The bottom edge of
the ground plate should overlap at the top edge of the lower back panel.
panel fit through the four ground plate keyhole slots. The bottom edge of
the ground plate should overlap at the top edge of the lower back panel.
3. Slide the ground plate down over the top of the upper-back panel of the
lower cabinet so the four screws attaching the upper-back panel fit
through the four lower ground plate slots.
through the four lower ground plate slots.
4. Ensure the exposed portion of the Time Division Multiplexing (TDM) bus
cable and inter-cabinet cables (ICC) do not get pinched between the
cabinets.
cabinets.
5. Tighten all screws.
6. Repeat this procedure for each cabinet.