High End Systems 2.0.0-EN Manuale Utente

Pagina di 466
Figure 5.7. The Clone DP window
5.2.8
Unpatching Fixtures
You can unpatch a fixture in order to repatch it with a different start address, or to stop DMX
output being sent to it. Unpatching does not erase any programming for the fixture in groups,
palettes, cues and so on.
There are two ways to unpatch. Unpatching by fixture removes all patching information for that
fixture, even if it has been patched to several start addresses or has multiple patch points. Un-
patching by start address only unpatches a specific start address, leaving other start addresses
associated with the fixture intact.
Unpatching by Fixture
To unpatch all patch information associated with a fixture:
1.
Setup
 
 
Patch
: open the
Fixture
window.
2.
Select the fixture by clicking on it, then press
Unpatch
at the top of the
Fixture
window. This unpatches the fixture, but leaves all programming for the fixture
intact.
3.
Click on
Apply Patch
or close the Fixture window to send the new patch in-
formation to the DP8000s.
Or, using the command line:
1.
Setup
 
 
Patch
: open the
Fixture
window.
113
High End Systems
Section 5: Adding, Patching, and Managing Fixtures