High End Systems 2.0.0-EN Manuale Utente
•
1
Thru
5
@
5
Thru
10
,
Enter
: fixture 1 has an intensity of 50% and fixture
5 an intensity of 10%.
6.4.4
Fanning Options
By default, fanning adjusts parameter values proportionally from the centre of the fixture selection.
You can have fanning work in other ways:
You can have fanning work in other ways:
•
Fan Normal: As described above, the middle fixture remains unchanged, while
the first and last fixtures' values change the most, in opposite directions. For
example:
the first and last fixtures' values change the most, in opposite directions. For
example:
30
30
30
30
30
Before fanning:
50
40
30
20
10
After fanning:
•
Fan From Start: The first fixture in the selection order remains unchanged,
while the last one's value changes the most. For example:
while the last one's value changes the most. For example:
30
30
30
30
30
Before fanning:
70
60
50
40
30
After fanning:
•
Fan From End: The last fixture in the selection order remains unchanged,
while the first one's value changes the most. For example:
while the first one's value changes the most. For example:
30
30
30
30
30
Before fanning:
30
40
50
60
70
After fanning:
•
Fan To Centre: the middle fixture remains unchanged, while the first and last
fixtures' values change the most, in the same direction. For example:
fixtures' values change the most, in the same direction. For example:
30
30
30
30
30
Before fanning:
50
40
30
40
50
After fanning:
You can set the fanning mode from the Fanning Toolbar:
•
Press and hold the
Fan
key to display the Fanning Toolbar; see Figure 6.10,
All subsequent fans will follow the currently selected fanning mode, until the editor is cleared.
Figure 6.10. The Fanning Toolbar
High End Systems
144
Section 6: Selecting Fixtures and Modifying Paramet-
ers