High End Systems 2.0.0-EN Manuale Utente
Section 24: Direct Control of DMX Channels
By default the DMX channel values output by the DP8000 are controlled by patched fixture data
as programmed in the Hog show file. However, you may wish to override these values with
manually entered DMX values or with Art-Net values streaming into the console from a remote
third party Art-Net source such as another console. Both of these tasks can be accomplished in
the DMX output window by following the instructions outlined in this chapter.
as programmed in the Hog show file. However, you may wish to override these values with
manually entered DMX values or with Art-Net values streaming into the console from a remote
third party Art-Net source such as another console. Both of these tasks can be accomplished in
the DMX output window by following the instructions outlined in this chapter.
Figure 24.1. DMX Output Window
24.1
Manually specifying DMX Channel Values
To set a dmx channel or group of channels to a specific value:
1.
Open the DMX Output window (press the SETUP key on the front panel and
select the DMX button on the main toolbar)
select the DMX button on the main toolbar)
2.
Use the two drop down menus at the top of the DMX Output window to select
the corresponding DP8000 and universe you wish the manilpulate
the corresponding DP8000 and universe you wish the manilpulate
3.
Double click on the desired dmx channel cell in the spreadsheet (or highlight
a group of dmx channel cells and press set)
a group of dmx channel cells and press set)
4.
Enter a valid dmx value (0 thru 255)
5.
Press enter to confirm (the value will now be displayed in blue)
24.2
Setting DMX Channels to External Art-Net Source
To set a dmx channel or group of dmx channels to values based on a remote Art-Net source:
341
High End Systems