High End Systems 2.0.0-EN Manuale Utente

Pagina di 466
2.
Undo the four screws front panel screws with a 3mm allen key (plus the two
thumb screws in the armrest on the Hog 4 console) , and carefully lift off the
front panel from the edge closest to you.
3.
Gently unplug the fader's cable lead from the main board
4.
Unscrew the fader's two front panel screws from the top side of the front
panel using a 2mm allen key and remove the fader.
5.
Fit the new fader in place ensuring that it sits completely flat against the PCB.
6.
Connect the new fader's cable led to the main board.
7.
To re-assemble follow disasembly steps in reverse order.
32.3
Cleaning Faders
Faders are often unnecessarily discarded when all they need is a clean:
1.
Remove the dirty fader. See Replacing Faders (p.425).
2.
Undo the top crosshead screw (furthest from the flying lead) using a small
Philips screwdriver.
3.
Remove the top end cap.
4.
Very carefully slide the whole mechanical assembly out from the other, bottom
end.
5.
Very carefully slide the track assembly out from the bottom end.
6.
Wipe tracks and wipers with a dry, clean tissue. Do not use solvents.
7.
Re-insert track assembly.
8.
Very carefully re-insert mechanical assembly.
9.
Fit top end cap and replace and tighten screw.
10. Replace the cleaned fader. See Replacing Faders (p.425).
32.4
Replacing the Trackball
!
Caution
Always shut down and disconnect the mains power before removing the
front panel.
To replace the Trackball:
High End Systems
426
Section 32: Service