Lowrance electronic X515C DF Manuale Utente
99
3. Select the fuel flow you want to rename and press
ENT
. The Device
Configuration menu will appear with the Device Name dialog box high-
lighted.
4. Press
4. Press
ENTER
and use
↑ ↓, ← → to input the desired name for the fuel
flow. Press
ENT
. Press
EXIT
repeatedly to get back to the main display.
To select a Location:
1. Press
MENU| MENU
, use
↑ ↓ to select
NMEA
2000
and press
ENT
. The
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
2. Highlight
B
US
S
ETUP
and press
ENT
, which will open the Bus Configu-
ration menu. A list of network devices will be at the top of the page.
3. Select the desired fuel flow and press
3. Select the desired fuel flow and press
ENT
. The Device Configuration
menu will appear.
4. Select
4. Select
L
OCATION
and press
ENT
, which will open the Location menu
with following options: Port, Center, Starboard and Unknown.
5. Highlight the desired location and press
5. Highlight the desired location and press
ENT
. The following message
will appear: Are you sure you wish to change this device's configuration?
5. Select
5. Select
Y
ES
and press
ENT
. Press
EXIT
repeatedly to return to the main
display.
Advanced Options menu
The Fuel Flow sensor Advanced Options menu contains two categories:
Advanced Options menu
The Fuel Flow sensor Advanced Options menu contains two categories:
Instance and Restore Defaults.
Instance
The Instance command is intended for use only by experienced NMEA
2000 network technicians. Instance allows network technicians to re-
solve certain electronic probe conflicts. This is most likely to occur if the
network includes LMF-200 or LMF-400 digital gauges, which support
the display of fewer electronic probes than your sonar unit.
If you want to use your unit in a network including one of these digital
If you want to use your unit in a network including one of these digital
gauges, you may need to consult customer service.
You should never need this command if you are connecting your unit to
You should never need this command if you are connecting your unit to
a network with similar display units and/or a series of electronic
probes.
Restore Defaults
The Restore Defaults command allows you to reset an individual EP-10
Fuel Flow Sensor's settings to factory defaults.