Desa VM42P Manuale Utente

www.desatech.com

108795-01N

WARNING: Installation of

this appliance should be done

by a qualiﬁed service person

well trained in the installation

of such appliances. You will

also need a building permit from

your local Building and Safety

Commissioner before installing

this appliance; otherwise your

insurance co. may not cover this

appliance.

NOTICE: This appliance is not

intended to be used as a primary

source of heat.

CAUTION: Do not connect

appliance before pressure test-

ing gas piping. Damage to gas

valve may result and an unsafe

condition may be caused.

The appliance and itʼs individual shutoff valve

must be disconnected from the gas supply piping

system during any pressure testing of that system at

test pressures in excess of 1/2 psig (3.5 kPa).
The appliance must be isolated from the gas sup-

ply piping system by closing its individual manual

shutoff valve during any pressure testing of the gas

supply piping system at test pressures equal to or

less than 1/2 psig (3.5 kPa).
For the purpose of input adjustment two pressure

taps (for IN and OUT pressures) are provided on

the gas control valve for test gauge connections

to the appliance.

INTRODUCTION

Continued

Figure 1 - Possible Locations for

Installing Appliance

INTERNAL WALL
INSTALLATION

CORNER
INSTALLATION

FULL
PROJECTION
INSTALLATION

FLUSH
INSTALLATION

SELECTING LOCATION

To determine the safest and most efﬁcient location

for your appliance, you must take into consider-

ation the following guidelines:
1. The location must allow for proper clearances

(see Clearances, page 7).

2. Consider a location where heat output would

not be affected by drafts, air conditioning

ducts, windows or doors.

3. A location that avoids the cutting of joists

or roof rafters will make installation easier.

Figure 1 shows a plan view of a few common

locations.

Flush installations

are recommended where

living space is limited or at a premium and since

the space required to enclose the appliance would

be located beyond an outside wall, this would also

reduce the cutting of joists, roof rafters and such.

Check local codes for any restrictions.
Projected installations

can extend any distance

into the room. A projection may be ideal for a new

addition on an existing, ﬁnished wall.
Corner installations

make use of space that may

not normally be used and provides a wider and

more efﬁcient range for radiant heat transference.
Internal wall installations

provide a discreet

option for room separation and can also be ideal

as an addition to an existing wall.