Desa CGCDV42PR Manuale Utente

www.desatech.com

116236-01G

26

4. Remount the new frame at the hinge with five

new screws before closing door. This will

ensure seating of the gasket.

5. Close glass door frame. Lock latches by placing

the bar under the tab on door and pushing down

and back on latch (see Figure 42, page 25).

6. Replace screen/rod assembly by reversing

step 1.

7. Replace louvers by reversing procedure under

Removing Louver Panels, page 25.

Cleaning Glass Door

See Cleaning and Maintenance on page 31.

INSTALLING LAVA ROCK AND
GLOWING EMBERS

It is very important to keep logs exactly as

installed. Do not modify logs. Only use log set

designed for this fireplace. Logs under log/grate

assembly are attached to burner. Do not attempt to

move these logs as this will damage logs.

WARNING: Logs are unitized

and attached to the grate. Do not

handle log/grate assembly by

logs. Always pick up by grate.

Open louvers, remove screen, unlock door latches

and open glass door. See Removing Glass Door,

steps 1 and 2, page 25.

1. Pull ember material apart into pieces no

larger than a dime. Place these pieces loosely

and sparingly directly onto the exposed front

section of the burner (see Figure 43). This

will create the glowing ember appearance

as the flame touches the ember material. Do

not block air slots by using too much ember

material in one area. It is not necessary to use

all of the ember material provided.

2. Pour lava rock onto plenum but not onto flat

burner. It is not necessary to use all of the lava

rock provided.

NOTICE: Do not put lava rock on

burner or under burner. Placing

lava rock on burner will cause

performance problems.

FIREPLACE

INSTALLATION

Continued

3. Close glass door, lock door latches, replace

screen and close louvers (see Removing Glass

Door, steps 5 through 7).

WARNING: The glass door

must be securely in place before

running this fireplace. Do not run

this fireplace if glass is missing

or broken.

Figure 43 - Placing Ember Material on

Burner

Embers

Plenum

INSTALLING BRICK LINER MODELS
BL42DA(SA) AND BL42DHA(SA)

WARNING: If fireplace has

been running, turn off unit. Let

cool before installing brick liner.

You may purchase brick liner from your local

retailer or see Accessories, page 42.

CAUTION: Always handle

brick panels with two hands.

Do not force brick panels into

place. Excessive force will break

brick panels.

1. Remove top and bottom louvers to allow ac-

cess to door latches.

2. Unlock door latches and open glass door. See

Removing Glass Door, steps 1 and 2, page 25.

3. Carefully remove lava rock and ember mate-

rial. Remove log/grate assembly by unscrew-

ing grate from plenum. The two logs under the

grate are attached to burner. DO NOT attempt

to remove.

4. Remove screws that attach plenum to burner

to remove plenum.

5. Remove three screws from deflector shield

on the inside top of firebox. Set shield and

screws aside.