Dacor OBS36 Manuale Utente
10
Parts List
Models oB36, oBs36, oB52 and oBs52:
A
Drip tray
G
Rotisserie rod and forks
B
Smoker box
H
Rotisserie motor
C
Warming rack
Match holder
D
Regulator assembly
Cleaning cream
E
Grills
F
Flame spreaders
Models oB52, oBs52 and oBsB162
K
Side burner grate
L
Side burner caps (2)
L
Side burner cover
M
Side burner heads (2)
lp Models equipped for use with an lp cylinder:
N
3/4” coupling
P
3/4” nipple
Installation Instructions
warning
Before installing the appliance, make sure the elec-
•
trical and gas (on tank-less installations) service
meets the requirements specified in the Planning the
Installation section of this manual.
This appliance must be installed by a licensed
This appliance must be installed by a licensed
•
plumber or gas fitter when installed within the
Commonwealth of Massachusetts.
Excessive weight warning: Since the appliance and
Excessive weight warning: Since the appliance and
•
grill cart are heavy, install the appliance with the help
of at least one other person.
Make sure the power cord is NOT connected to the
Make sure the power cord is NOT connected to the
•
electrical outlet while connecting the gas line to the
appliance.
Do not apply excessive pressure when tightening con-
Do not apply excessive pressure when tightening con-
•
nections and fittings.
Do not use plumber’s putty or Teflon tape on gas com-
Do not use plumber’s putty or Teflon tape on gas com-
•
pression connections. Doing so can defeat the proper
sealing of these fittings.
Use only approved gas line thread compound or tape
Use only approved gas line thread compound or tape
•
to seal gas connections.
The maximum gas supply pressure to the regulator
The maximum gas supply pressure to the regulator
•
must not exceed 1/2 pound per square inch.
Preparing for Installation
Before removing the unit from the box, check the
1.
labeling on the box to make sure that the appliance is
equipped for the gas type to be used. Liquid petroleum
(propane) units are identified by the “LP” designa-
tion at the end of the model number. Do not proceed
with installation if you do not have the correct model.
Conversion in the field from one gas type to another is
not permissible.
With the help of an assistant, remove the appliance
With the help of an assistant, remove the appliance
2.
and all the parts from the box. Check to make sure all
parts are included.
Remove all shipping materials from the appliance and
Remove all shipping materials from the appliance and
3.
peel off the protective plastic coating.
To reduce weight during installation, make sure all
To reduce weight during installation, make sure all
4.
loose parts are removed from the grill.
A
C
B