Lexicon MC-1 Manuale Utente

11

MC-1 Digital Controller

S

ystem

Configuration

Restore Factory Defaults

Although the MC-1 memory is cleared before it leaves the factory, it is
good practice to restore the factory defaults with the following procedure
before system configuration.

Turn the MC-1 OFF with the remote control. Turn the unit back ON and
immediately press and hold the MUTE button on the remote. (Make sure
you do not block the infrared receiver on the MC-1 front panel.) The
display will read:

Press 

▼

 to highlight RESTORE DEFAULTS, then press SELECT. This

will clear and reload all preset effects and all factory settings of Volume,
Balance, Contrast, Configuration, etc. When the message FACTORY
DEFAULTS RESTORED is displayed, press DONE to return to normal
operation.

Equalization

In the main menu, press SELECT to open the Equalization menu which
contains Bass, Treble and Tilt controls, and a Loudness parameter.

▲

▼

Adjust with       or

Bass and Treble level controls are provided to compensate for inconsis-
tencies in source material, rather than variations in room conditions. The
BASS LEVEL control allows a boost or cut of as much as 6dB below
250Hz. The TREBLE LEVEL control allows a boost or cut of 6dB above
1.5kHz. To select either control for adjustment, use 

▲

 or 

▼

 to select the

control, press SELECT, and use  

▲

 or 

▼

 to adjust the setting.

These controls do not affect the sound of rear or side speakers.