3com WX2200 3CRWX220095A Manuale Utente

C

HAPTER

 11: M

ANAGED

 A

CCESS

 P

OINT

 C

OMMANDS

„

tx-power power-level 

— Number of decibels in relation to 

1 milliwatt (dBm). The valid values depend on the country of 
operation.

The maximum transmit power you can configure on any 3Com radio 
is the maximum allowed for the country in which you plan to operate 
the radio or one of the following values if that value is less than the 
country maximum: on an 802.11a radio, 11 dBm for channel numbers 
less than or equal to 64, or 10 dBm for channel numbers greater than 
64; on an 802.11b/g radio, 16 dBm for all valid channel numbers for 
802.11b, or 14 dBm for all valid channel numbers for 802.11g.

Defaults — The default transmit power on all MAP radio types is the 
highest setting allowed for the country of operation or highest setting 
supported on the hardware, whichever is lower.

Access — Enabled.

History —Introduced in MSS Version 3.0. Version 6.0 removed the dap 
option.

Usage — You also can configure a radio channel on the same command 
line. Use the channel option.

This command is not valid if dynamic power tuning (RF Auto-Tuning) is 
enabled.

Examples — The following command configures the transmit power on 
the 802.11a radio on the MAP access point connected to port 5:

WX1200# set ap 5 radio 1 tx-power 10

success: change accepted.

The following command configures the channel and transmit power on 
the 802.11b/g radio on the MAP access point connected to port 1:

WX1200# set ap 1 radio 1 channel 1 tx-power 10

success: change accepted.

„

„