Accusplit AE2720 Dépliant

Once you put on your pedometer with the cover closed, 

it will automatically begin to record your steps, and 

activity time. Repeatedly press the red MODE button to 

cycle through the pedometer modes:  

STEP → ACTIVITY TIMER → STEP

ACCUSPLIT has added a “2 step delay” filter to this 

pedometer, to weed out false steps caused by tapping 

the foot, sitting down, etc. The filter is set to “2 steps,” 

meaning that the unit will wait to start counting steps 

until more than two steps have been recorded. When 

you are beginning a walk, the display will not show any 

steps for a few seconds. After the unit has sensed three 

steps, the display will register all of those steps at once, 

and keep counting from that point.

Most people prefer to reset step counts daily. To reset: 

press and hold the white RESET button for at least 2 

seconds.

When the display starts to dim or goes blank, it is time to 

replace the battery. Your pedometer uses one Type L1142 

(LR43) 1.5 volt silver oxide battery.  

Attach the pedometer to the 

leash by looping the leash 

through the pedometer leash 

slot. Next, loop the leash 

through the metal clip, then 

clasp the waistband of your 

clothing with the pedometer 

belt clip.  

Note: You can also use a safety 

pin to fasten the leash to 

your clothing, loop the leash 

through your belt or belt loop, 

or use a badge holder.

ACCUSPLIT, Inc.  •  6120 Stoneridge Mall Rd., Suite 210  •  Pleasanton, CA 94588 USA

800-965-2008  •  925-226-0888  •  FAX 925-463-0147  •  www.ACCUSPLIT.com  •  support@ACCUSPLIT.com

Congratulations on taking the first step to wellness 

with your purchase of an ACCUSPLIT pedometer. 

It’s easy to set up your new pedometer. 

Just follow the steps below, and start walking!

Red: 

MODE

ACCUSPLIT 

EAGLE

�

STEP

▶

White: 

RESET 

970-076B

10/08

•  STEP: STEP mode shows 

your step count since last reset, 

up to 1,000,000 steps.

◯

MODE shows total activity 

time in minutes and seconds 

since last reset. The timer runs 

automatically whenever steps  

are being recorded.

See diagrams at right.
The cover must be closed for the  

pedometer to work.

ACCUS

PLIT

ALLIANC

E

A

CCU

STEP10000.OR

G    RESET�

0

68440

Gently slide the pedometer onto 

your belt or the top edge of your 

pants or skirt. It should fit snugly 

and level, above one knee. The 

strong polycarbonate clip makes 

it easy.
Note: The pedometer should be as vertical as possible. 

Walkers with larger stomachs may find it helpful to wear 

the pedometer farther back on the body, toward one hip. 
The cover must be closed for the pedometer to work. 
To avoid losing or dropping your pedometer, use the 

included leash and clip to fasten the pedometer securely 

to your clothing.

yes

no

(Badge holder  

not included)

1. Insert a coin into the slot on the front of the  

  case, and twist counterclock-wise to loosen  

  the battery door.
2. Remove battery door and take out the old  

  battery. Replace it with a new battery. The  

  battery’s positive (+) terminal should be  

  FACE UP while you put it into the  

  pedometer.
3. Put the battery door back on and twist the  

  coin clockwise to tighten.