3com WX4400 3CRWX440095A Manuale Utente
set ap auto
363
The profile uses the default radio profile by default. You can change the
profile using the set ap auto radio radio-profile command. You can
use set ap auto commands to change settings for the parameters listed
in Table 71. (The commands are listed in the “See Also” section.)
profile using the set ap auto radio radio-profile command. You can
use set ap auto commands to change settings for the parameters listed
in Table 71. (The commands are listed in the “See Also” section.)
Examples — The following command creates a profile for automatic
Distributed MAP configuration:
Distributed MAP configuration:
WX1200# set ap auto
success: change accepted.
See Also
Table 71 Configurable Profile Parameters for Distributed MAPs
Parameter
Default Value
MAP Parameters
bias
high
blink
(Not shown in display ap config
output)
output)
disable
force-image-download
disable (NO)
group (load balancing group)
none
mode
disabled
persistent
none
upgrade-firmware
(boot-download-enabled)
(boot-download-enabled)
enable (YES)
Radio Parameters
radio num auto-tune
max-power
max-power
default
radio num mode
enabled
radio num radio-profile
default
radiotype
11g
(or 11b for country codes where
802.11g is not allowed)
802.11g is not allowed)