3com WX4400 3CRWX440095A Manuale Utente

This command does not apply to any gigabit Ethernet ports or to ports 7 
and 8 on the WX1200 switch or port 3 on the WX2200 switch. 

To manage a MAP access point on a switch model that does not have 
10/100 Ethernet ports, use the set ap command to configure a 
Distributed MAP connection on the switch. 

Examples — The following command sets ports 1 through 3 and port 5 
for MAP access point model AP2750 and enables PoE on the ports:

WX1200# set port type ap 1-3,5 model ap2750 poe enable

This may affect the power applied on the configured ports.

Would you like to continue? (y/n) [n]y

The following command sets ports 1 through 3 and port 5 for MAP 
access point model AP7250 and enables PoE on the ports:

WX1200# set port type ap 1-3,5 model ap7250 poe enable

This may affect the power applied on the configured ports.

Would you like to continue? (y/n) [n]y

The following command sets ports 1 through 3 and port 5 for MAP 
access point model AP8250 and enables PoE on the ports:

WX1200# set port type ap 1-3,5 model ap8250 poe enable

This may affect the power applied on the configured ports.

Would you like to continue? (y/n) [n]y

The following command sets ports 1 through 3 and port 5 for MAP 
access point model AP8750 and enables PoE on the ports:

WX1200# set port type ap 1-3,5 model ap8750 poe enable

This may affect the power applied on the configured ports.

Would you like to continue? (y/n) [n]y

The following command resets port 5 by clearing it:

WX1200# clear port type 5

This may disrupt currently authenticated users. 

Are you sure? (y/n) [n]y

success: change accepted.

Port groups

Not applicable

IGMP snooping

Enabled as users are authenticated and join VLANs.

Maximum user 
sessions

Not applicable

Table 17   MAP Access Port Defaults (continued)