Cisco Systems 2960 Manuale Utente

Pagina di 1004
 
37-3
Catalyst 2960 and 2960-S Switch Software Configuration Guide
OL-8603-09
Chapter 37      Configuring EtherChannels and Link-State Tracking
Understanding EtherChannels
The EtherChannel provides full-duplex bandwidth up to 800 Mb/s (Fast EtherChannel) or 8 Gb/s 
(Gigabit EtherChannel) between your switch and another switch or host. Each EtherChannel can consist 
of up to eight compatibly configured Ethernet ports. 
All ports in each EtherChannel must be configured as Layer 2 ports. The number of EtherChannels is 
limited to six. 
For more information, see the 
You can configure an EtherChannel in one of these modes: Port Aggregation Protocol (PAgP), Link 
Aggregation Control Protocol (LACP), or On. Configure both ends of the EtherChannel in the same 
mode:
  •
When you configure one end of an EtherChannel in either PAgP or LACP mode, the system 
negotiates with the other end of the channel to determine which ports should become active. 
Incompatible ports are put into an independent state and continue to carry data traffic as would any 
other single link. The port configuration does not change, but the port does not participate in the 
EtherChannel.
  •
When you configure an EtherChannel in the on mode, no negotiations take place. The switch forces 
all compatible ports to become active in the EtherChannel. The other end of the channel (on the other 
switch) must also be configured in the on mode; otherwise, packet loss can occur.
You can create an EtherChannel on a standalone switch, on a single switch in the stack, or on multiple 
switches in the stack (known as cross-stack EtherChannel). See 
 and 
If a link within an EtherChannel fails, traffic previously carried over that failed link moves to the 
remaining links within the EtherChannel. If traps are enabled on the switch, a trap is sent for a failure 
that identifies the switch, the EtherChannel, and the failed link. Inbound broadcast and multicast packets 
on one link in an EtherChannel are blocked from returning on any other link of the EtherChannel.
Figure 37-2
Single-Switch EtherChannel
Switch 1
Catalyst 2960-S switch stack
Switch 2
Channel
group 1
Channel
group 2
Stack port
connections
Switch 3
Switch A
277955