Fiesta Products 7305 Manuale Utente

TRAXXAS • 5

TOOLS, SUPPLIES AND REQUIRED EQUIPMENT

Your model comes with a set of specialty metric tools. You’ll need to purchase other items, available from your hobby dealer, to operate 
and maintain your model.

REQUIRED EQUIPMENT 

(sold separately)

For more information on 
batteries, see Use the Right 
Batteries on page 11.

SUPPLIED TOOLS AND EQUIPMENT

TR

AX

XA

S

APPLYING THE DECALS

The main decals for your model 

have been applied at the factory. 
The decals are printed on self-
adhesive clear mylar and are die-
cut for easy removal. Use a hobby 
knife to lift the corner of a decal 
and lift it from the backing. To 
apply the decals, place one end 
down, hold the other end up, and 
gradually smooth the decal down 
with your finger as you go. This 
will prevent air bubbles. Placing 
both ends of the decal down and 
then trying to smooth it out will 
result in air pockets. 

Look at the photos on the box for 

typical decal placement.

TIRE GLUING

The factory tires on your model are not glued to the rims. The 
instructions here are provided to show you how to glue tires to the 
rims if desired, but it is not necessary to run your model. If you plan 
to upgrade to the Velineon VXL-3m Brushless Power System in the 
future, tire gluing is mandatory. Use CA tire glue available from your 
local hobby dealer. 
1. Remove a wheel from the model using the 

larger (7mm) end of the universal wrench.

2. Use your thumb to push the side of the 

tire away from the rim. Place one or two 
drops of CA glue into the opening and 
release the tire. Capillary action will draw 
the glue around the bead of the tire.

3. Repeat step two at four or five points 

around the rim, until the tire is completely 
secured to the rim. Turn the rim over and repeat the process for the 
inside of the rim/tire. Repeat for the other three wheels.

4. Reinstall the wheels, make sure none of the axle pins have fallen out 

from behind the hex hubs.

DECORATING YOUR MODEL