Cisco Systems C9800HDN Manuale Utente
2
2-2
Setting up Network Servers
Typical system combinations are:
• Print server running Windows NT 4.0/2000/Server 2003 Server; clients running
Windows NT 4.0/2000/XP/Server 2003 Workstation and Windows 98/Me
• Print server running Windows NT 4.0/2000/XP/Server 2003 Workstation and
clients running Windows 98/Me
With TCP/IP protocols loaded, you can run Fiery utilities and Fiery WebTools from a
Windows computer.
Windows computer.
Tips for experts—Windows with TCP/IP
Setting up printing from Windows using TCP/IP protocols is similar to setting up
UNIX workstations with TCP/IP. When TCP/IP network connections are made from
Windows NT 4.0/2000/XP/Server 2003 workstations, note the following:
UNIX workstations with TCP/IP. When TCP/IP network connections are made from
Windows NT 4.0/2000/XP/Server 2003 workstations, note the following:
•
Make sure you have a valid IP address for the Fiery and any workstations that will print
to it or run the Fiery utilities.
to it or run the Fiery utilities.
•
In Fiery Setup, enable TCP/IP and enter the IP address, subnet mask, and gateway
address for the Fiery.
address for the Fiery.
Enter these addresses manually or use DHCP or BOOTP protocols to assign them
dynamically.
dynamically.
•
Make sure the Fiery name and address are listed in a domain name server (DNS) or
host name database used by your system.
host name database used by your system.
•
Make sure the system host table includes the correct internal name for the Fiery as a
remote printer.
remote printer.
For more information, see
•
For Windows, install the appropriate printer driver files on the Windows NT 4.0/2000/
Server 2003
server.
For more information, see the
.
•
Repeat the installation for all users who print to the Fiery.
Each server and workstation running the Fiery utilities with TCP/IP also needs the
TCP/IP protocol and the Fiery utility software.
TCP/IP protocol and the Fiery utility software.