Windsor SP20-10090310 Manuale Utente

86309580   FLOOR POLISHER 10/08/08 

High starting torque. Hold machine firmly with 
both hands. 
 
1.  Ensure that the pad driver is in good shape. 

Install or change pad if necessary. 

 
2.  Plug the machine into a wall outlet as 

described in the grounding instructions. 

 
3.  Lower the handle by unlocking the adjustment 

handle and moving the handle into position. 
Relock the handle when it is in a comfortable 
position. 

Insure that handle is locked in position before 
starting machine. 
 
4.  Push the safety lock forward, unlocking the 

switch levers. 

 
5.  With the safety lock forward, squeeze one or 

both of the switch levers, turning the machine 
on. (These levers can be operated 
independently of each other). The safety lock 
will not re-engage until both levers are 
released. 

 
6.  To stop the machine, release the switch 

levers.  

 
7.  Do not let machine rest on pad.  When 

finished with the machine, return handle to the 
storage position.   

 
NOTE:  The machine is equipped with a circuit 
breaker to protect the motor in the event an 
overload condition occurs. The circuit breaker 
is located on the handle. Push the reset button 
to restart the machine. If the breaker trips 
again, correct the cause of overloading before 
proceeding. 

1.  Inspect power cord for wear. To prevent 

electrical shock replace cords with frayed or 
cracked insulation immediately. 

 
2.  Place machine in the storage position. 
 
3.  Check pad condition. Change if soiled or torn. 
 

1.

Lay machine back, exposing the under side. 

 
 
 

 
Ensure pad is centered on pad driver.  Pull pad to 
edge of pad driver in several directions to check 
for proper engagement. 
 
NOTE:  Use care when replacing center lock to 
prevent cross threading.