Smeg SC712U Manuale Utente

•

Proper installation is your responsibility. Have a qualified technician install this oven. Make sure
you have everything necessary for proper installation. It is the responsibility of the installer to comply
with installation information specified on the model/serial ID plate. The model/serial ID plate can be
found on the internal frame of the oven when the door is opened.

•

Have your oven installed and properly grounded by a qualified installer, in accordance with
these installation instructions. Grounding is mandatory according to the provisions of electrical
safety codes. If this appliance is connected to an external electrical power supply, it must be
grounded in compliance with local codes, or, if no local codes exist, in compliance with the national
ANSI / NFPA 70 code of electrical regulations.

•

Make sure that the voltage and frequency of the power supply line correspond to the information
indicated on the model/serial ID plate. A multi-polar cut-out switch must be available on the supply
line with a contact gap equal to or greater than 3 mm, located in an easily accessible position near
the appliance.

•

Do not attempt to repair or replace any part of your oven unless it is specifically recommended in this
manual. All other service procedures should be performed by a qualified technician.

•

This oven is not suitable for installation and operation in mobile homes or recreational vehicles.

•

Electrical grounding is required. See the “Electrical Requirements” section. It is the customer’s
responsibility:

-  To contact a qualified electrical installer,
-  To make sure that the electrical system is adequate and in compliance with the national ANSI /

NFPA 70 ELECTRICAL CODE – latest edition – or the CANADIAN ELECTRICAL CODE,
C22.11 – 1982 and C22.2 No. 01982 – or latest edition – and all local codes and ordinances.
IMPORTANT: Observe all governing codes and ordinances.