Lightolier 302MREX Dépliant
631 Airport Road, Fall River, MA 02720 • (508) 679-8131 • Fax (508) 674-4710
We reserve the right to change details of design, materials and finish.
www.lightolier.com © 2008 Philips Group • B1008
We reserve the right to change details of design, materials and finish.
www.lightolier.com © 2008 Philips Group • B1008
Job Information
Type:
Job Name:
Cat. No.:
Lamp(s):
Notes:
Lytecaster Recessed Downlighting
302MREX
Page 1 of 1
3 3/4" (95mm) Aperture Low Voltage MR16 12V Standard Frame-In-Kit (Non-IC)
Lightolier is a Philips group brand
Power Pack
Cut Out
Reflector Trim
302MREX (120V)
3-3/4" (95mm)
Accepts most 3-3/4" (95mm) 300 series trims; see Reflector
Trim specification sheets.
Trim specification sheets.
Complete fixture consists of Reflector Trim & Frame-In Kit. Select each separately
Features
1. Mounting Frame: 20ga. galvanized steel. Four slots are positioned 90º
apart to simplify alignment.
2. Mounting Bars: (4) 18 ga. galvanized steel. 13" (330mm) long bars extend
to 27" (686mm), rotatable and lockable, integral T-bar tabs. Spike detail
eliminates the need of additional nailing.
eliminates the need of additional nailing.
3. Mounting Bars Locking Clip: (1) locks mounting bars in place.
4. Snap-on Socket Cup: 22ga. galvanized steel. Easy snap-on to housing.
5. Socket: Porcelain body ; Two-pin (GX5.3 base) Pre-wired with 18 ga. Teflon
4. Snap-on Socket Cup: 22ga. galvanized steel. Easy snap-on to housing.
5. Socket: Porcelain body ; Two-pin (GX5.3 base) Pre-wired with 18 ga. Teflon
250º leads to junction box.
6. Transformer: Electronic, 60VA, Class 2 Transformer, 120 volt primary,
nominal 12 volt secondary, class "H".
7. Junction Box: 4" (102mm) x 3" (76mm) x 2" (51mm) 18 ga. galvanized steel .
CSA/UL certified for maximum of 8 No. 12 ga. 90º C through branch circuit
conductors. Integral cable clamp permit attachment of non metallic Loomex
without need of additional connectors. Pry-out knock-outs accept BX cable.
Easy access from both sides with snap-on covers.
conductors. Integral cable clamp permit attachment of non metallic Loomex
without need of additional connectors. Pry-out knock-outs accept BX cable.
Easy access from both sides with snap-on covers.
8. Thermal Protector: Meets CSA/UL requirements. Insulation, if used,
must be kept 3" (76mm) away from luminaire sides and junction box.
Accessories
Mounting Bars Extenders: 1964
20" (508mm) long. Set of 2
20" (508mm) long. Set of 2
Mounting Bar Locking Clips: 0098
To lock mounting bars in place after installation. Set of 12.
To lock mounting bars in place after installation. Set of 12.
Labels
Damp or Wet location rated depending on trim used.
9-1/2"
(244mm)
7"(175mm)
14"(356mm) MIN.
25"(635mm) MAX.
12-1/2"
(315mm)
5-3/4"
(146mm)