Regency U39-NG1 Manuale Utente

Regency

®

 U39 ULTIMATE Direct Vent Freestanding Gas Stove

Minimum Installation Height:

U39: 59-3/4" ( 1518mm)

DV Stove Horizontal Vent Kit (2 ft. Part # 946-116 or 4 ft. Part # 946-216) includes all the parts needed to install the U39 with  minimum horizontal 
and vertical vent dimensions. For installations that require longer vertical and/or horizontal vents 
see the "Dura-vent Termiantion Kit and Component" sections. 

    Qty.  Description
1) 1 

Rigid Pipe Section (Kit # 946-116: 2 ft. (1.2m) length,

 

 Kit # 946-216: 4 ft. (1.2m) length), 6-1/2" (165mm) inside diameter 

2) 1 

Flex Liner, compressed aluminium 2 ply liner, 

 

 4" (102mm) inside diameter

3) 4 

spring spacers

4) 1 

90 deg. Elbow

5) 1 

Adjustable pipe section 13-1/2" to 24" (343mm x 610mm), 2 pieces

6) 1 

Thimble Cover

7)  1 Wall Thimble (2 pcs.)
8) 1 

Adapter 

9) 1 

AstroCap Termination Cap

10) 2 Trim Collar
11) 1 tube of Mill-Pac, high temperature sealant
12) 12 Screws, #8 x 1/2" Self tapping, Stainless Steel
13) 13 Screws, #8 x 1/2" Self tapping, Black
14) 4 Screws #8 x 1-1/2" Drill Point, Black
15) 4 Screws #8 x 1-1/2" Drill Point, Stainless Steel
16) 8 Wood screws #8 x 1"

Optional:
946-206  Vinyl Siding Standoff for AstroCap

Review the following sequence of 
instructions which are typical of most 
installations. The sequence may vary 
depending on wall thickness. Refer to  vent 
location and clearance dimensions in 
"Exterior Vent Termination Locations" 
to "DV Stove Horizontal Vent Kit" 
sections.

1)  Set the unit in its desired location. 

Check to determine if wall studs will 
be in the way of the venting system, 
adjust location until all clearances are 
met and there are no obstructions.

2) Assemble 

a 

trial fi t to determine the vertical 

center-line for the vent termination.

 

a)  Cut a 9-1/2" x 9-1/2" (241mm x 241 

mm) square hole on both the interior 
and exterior wall.

 

b)  Install wall thimbles on both interior 

and exterior wall with 4 wood screws 
(#8 x 1") per thimble.

 

c)  Attach the 2 piece adjustable pipe 

section to the vent terminal and 
slide into position from the exterior. 
The larger diameter end of the 
adjustable pipe goes to the vent 
terminal.

 

d)  Install the 90

o

 elbow onto the 

adjustable pipe to determine the 
vertical centerline of the starter collar 
on the unit.