Lopi Direct Vent Freestanding Stove Manuale Utente

Pagina di 42
Finalizing the Installation
 (for qualified installers only)
  
1 9
Travis Industries
1 0 0 - 0 1 1 4 2
4 0 5 0 1 1 4
Glass Removal
WARNING
   :
Make sure the gas control valve is “OFF” and the heater is cool prior to conducting service.
Lift the stove top off the 
stove and place 
it aside.
a
Twist 1/4 turn.
The spring pin will 
disengage from the 
latch bracket, 
opening the latch.
Latch Bracket
Insert the 1/4” key 
into the spring 
pin.
Glass
Top of 
Firebox
Spring Pin
Re-Attaching the Glass Frame:
a)
Slide the two brackets on the bottom of the glass frame into the 
glass frame guides (hold the glass frame at a slight angle.
b)
Swing the glass frame into place - you may have to lift it slightly 
to allow it to fit over the top of the firebox.
c)
Attach the upper latches (follow the instructions above in reverse).
d) Replace the stove front, doors, and top.
Open the two latches holding the glass frame in 
place  - follow the directions shown below
Lift the face of the stove up, swing 
the bottom out, and slide it down.  
Place it aside.
d
Lift the glass frame slightly, swing the top forward, then lift 
the glass frame to disengage it from the bottom guides.
Glass Frame Guide
AA
AA
Glass Frame
b
Swing the 
doors open, 
lift them off 
the hinges, 
and place 
them aside.
NOTE
If the face does not slide away, 
loosen the screws holding these 
tabs in place.
c