JVC GV-LS2 U Manuale Utente
27
Preparation
Establishing a wired connection
When establishing a wired connection to the computer or access point, attach the supplied LAN cable as follows.
Required operating environment
Browser: Internet Explorer 9 or later
Browser: Internet Explorer 9 or later
1
Set the network mode switch to "LAN(OFF)".
DIRECT WLAN LAN(OFF)
DIRECT WLAN
RESET
LAN(OFF)
ETHERNET
DC
AV
MIC
PLUG IN POWE
R
• If the network mode switch is set to [DIRECT] or [WLAN], the LAN terminal cannot be used.
• While the power is on, switching the network mode switch does not change the setting.
• While the power is on, switching the network mode switch does not change the setting.
2
Attach the conversion cable to the stopper of the LAN cable.
3
Attach the LAN cable to the unit in numerical order.
MIC
PLUG IN
POWER
AV
EXTEN
D
DC
MIC
PLUG IN
POWER
AV
EXTEN
D
DC
MIC
PLUG IN
POWER
AV
EXTEN
D
DC
• Attach the cable without twisting.
• When using a tripod, make sure the cable does not come into contact with its handle.
• Do not put obstacles near the cable. Otherwise, the pantilter may not move properly.
• Do not use cables (AV cable, microphone, etc.) with L-shaped connecters.
• The center position of the camera may differ slightly under circumstances such as at low temperatures; however,
• When using a tripod, make sure the cable does not come into contact with its handle.
• Do not put obstacles near the cable. Otherwise, the pantilter may not move properly.
• Do not use cables (AV cable, microphone, etc.) with L-shaped connecters.
• The center position of the camera may differ slightly under circumstances such as at low temperatures; however,
this is not malfunction.
4
Connect the camera to your computer via the LAN cable.
Hold the joint gently and insert.
Stopper
1
2
3