American Standard 6723 Dépliant

Certified to comply with ANSI A112.18.1
U.S. Patent No. D403,750

M 9 6 8 2 1 6 C

Install the WALL ESCUTCHEON (7) on the MOUNTING PLATE  (5). Place the ROBE HOOK (1), TOWEL RING (2) and 
TISSUE PAPER HOLDER (3) over the ESCUTCHEON (7). Secure with MOUNTING SCREW (8). Tighten fully.

Push INDEX BUTTON (9) into ROBE HOOK (1), TOWEL RING (2) and TISSUE PAPER HOLDER (3). See illustration.

The ROBE HOOK (1), TOWEL RING (2) and TISSUE PAPER HOLDER (3) work best if secured to a wall stud or cross brace within the wall, 
using the SCREWS (3) supplied.

If the ROBE HOOK (1), TOWEL RING (2) and TISSUE PAPER HOLDER (3) is to be installed on a tile or plaster wall the TILE ANCHORS (4)
 or DRYWALL ANCHORS (6) and SCREWS (3) should be used.

Determine desired height and location (optional) and mark a center line. Using the MOUNTING PLATE (5) as a template mark the two
mounting holes. If MOUNTING PLATE (5) is secured to a stud or cross brace drill small pilot holes for SCREWS (3).

 use DRYWALL ANCHORS (6) and SCREWS (3) for securing MOUNTING PLATE (5) to wall. Place #2 Phillips 

screwdriver or cordless screwdriver into recess of anchor. Press into drywall while turning the anchor clockwise until it is seated flush 
with the wall.  Place MOUNTING PLATE (5) over DRYWALL ANCHORS (6) and insert SCREWS (3) with #2 Phillips screwdriver. 
See illustration below.  Secure MOUNTING PLATE (5) to wall with SCREWS (3).

FINISHED
WALL

Regular Screwdriver

Phillips Screwdriver

Drill

10'

Tape Measure

If TILE ANCHORS (4) and SCREWS (3) are used for securing MOUNTING PLATE (5), then drill 

two 1/4" diameter holes a minimum of 1-1/4" deep. Insert the two TILE ANCHORS (4) flush with face of the finished wall. 
Secure MOUNTING PLATE (5) to wall with SCREWS (3).

30 TO 72 

INCHES FROM

FLOOR

USE MOUNTING PLATE 
AS TEMPLATE

CENTER
LINE