CRU Data Express DE75 6056-0000-0000 Dépliant

Receiving Frame Motherboard (Rear View)

DC Power Connector (P1): The Data Express uses a standard 
4-pin DC Power Connector to accept DC power.

I/O Connector (JP1): The input/output connector provides a 
standard interface for all IDE signals.

ID0: Jumper installed on Pins 1 & 2 (Factory Default) for 
Master configuration.

ID1: Jumper installed on Pins 3 & 4 for Slave configuration.

Remote Drive Activity (JP6 RLED): Pins 17 & 18 are used for 
remote drive activity.

Jumper (JP6 DDA): Factory-installed on Pins 15 & 16 - Do not 
remove!

JP4 Option: Refer to the full version of the DE75i-A100 Manual 
for further information.

There are two (2) ways to set the Master/Slave drive designation 

for the DE75i-A100 unit.

Method 1 (Recommended)

Using the factory-installed jumper on your IDE drive

In most cases, the drive will be factory-configured as a Master 

Ultra ATA133 drive using a jumper plug on the drive itself. No 

configuration changes are required. For multiple drive configura-

tions, it is necessary to set the first IDE drive as Master and the 

second IDE drive to Slave. This can be done by changing the 

jumper on the Ultra ATA133 drive itself (refer to your drive manu-

facturer documentation). 

This method requires no additional configuration of the drive car-
rier circuit board. 

Drive Installation Overview

Drive 

Carrier

#6-32 x 3/16

Flat HD Screw

(6 Total)

I/O Cable

Drive 

(Not Included)

Protective 

Drive Cover 

(Provided)

Power Cable

Receiving Frame 

Motherboard

DC Power 

Connector

I/O Connector

JP4 Option

Jumper (Do not remove)

ID0

}

 

Master/Slave

   

ID1

    

Configuration

= Pin 1