CRU DP25 SL Carrier Only, SATA 8601-5009-5500 Dépliant

The DataPort 25 SL is a low profile DataPort designed to fit into 
small form factor 3.5” drive bays.  The DataPort 25 SL holds one 
SATA 2.5” hard drive.

1. Locate an available 3.5” drive bay and remove the front bezel.

2.  If your computer requires mounting rails, install the rails on the 

DataPort 25 SL frame and slide it into the computer and ensure 
it is properly secured.

3.  If your computer does not require mounting rails slide the 

DataPort 25 SL frame into the computer drive bay and  
secure it with the provided mounting screws.

4.  Locate and connect an available 4-pin power connector (used 

for floppy drives) to the back of the DataPort 25 SL frame.  

5.  Locate an available SATA data cable and connect it to the back 

of the DataPort 25 SL frame to the left most SATA connector 
(see picture for details).

Your frame installation is complete.

1.  Remove the two screws from the back of the SL Carrier.  Slide 

the metal cover off. Note: Do NOT use screws longer than 
those supplied as the circuit board will be damaged.

Use this SATA data connector

Power connector

2.  Install the hard drive upside-down.  Connect the hard drive 

(upside-down) to the connector on the circuit board with the 
bottom of the hard drive facing upwards. Then use the pro-
vided screws to secure the hard drive.

3.  Slide the cover back on to the carrier and secure it with the 

cover screws.

Warning!  The DataPort 25 SL is not interchangeable with 
any other DataPort 25 products.  Due to size limitations 
the DataPort 25 SL carrier will not fit properly into other 
DataPort 25 frames.  Any attempt to do so could result in 
the loss of data.  The DataPort 25 SL frame will only sup-
port the DataPort 25 SL carrier.  Any other carrier will not fit 
properly into the DataPort 25 SL and could damage it.