Philips SRP2008B/86 Manuale Utente

4

EN

5

EN

2.2  Setting up the universal remote control

The example below instructs you how to set up your

universal remote controls for your TV.

You can repeat the same steps for other devices which you

want to operate, using the SRP2008B.
The remote control can be set up to operate any 8 of the

following devices:

Device name

Description

TV

Traditional TV, flat screen TV and

projection TV, TV part of TV / VCR, TV /

VCR / DVD and TV / DVD combos

SAT

Satellite receiver, Digital Satellite System

(DSS), Direct Broadcast Satellite (DBS)

Cable

Cable box, Internet Protocol TV (IPTV),

High Definition Television decoder

(HDTV)

DVD

DVD player, Blu-Ray player, High

Definition DVD player (HD-DVD),

DVD part of TV / DVD, TV / VCR /

DVD and VCR / DVD combos

TV-2

Traditional TV, flat screen TV and

projection TV, TV part of TV / VCR, TV /

VCR / DVD and TV / DVD combos

DVB-T

Digital Video Broadcasting Terrestrial

device, Free To Air TV

DVR

DVD recorder (DVDR), DVD / Hard

Disk Drive combination (DVDR-HDD)

VCR

Video cassette player / recorder, VCR

part of TV / VCR, TV / VCR / DVD and

VCR / DVD combos

Example: setting up the universal remote control to

operate your TV:

1

  Switch ON the TV manually or use the original remote

control for this. Tune to channel 1.

2

  Press and hold the

device selection button

for 5 seconds until the red

LED   lights up.

 •

The remote control is

now

in setup mode.

3

  Look up the 4-digit

code for your brand in the

brand list at the back of this

user manual.

  A four-digit code is shown

for each brand.

  Use the digit buttons to

enter the code for your

brand.

 •

 

If the red LED  

turns off, an invalid code

was entered. In this case,

try again.

4

  Aim the remote control at

the TV. Press and hold the

button. Release it

immediately release it as

soon the TV switches off.

 • This step normally takes

between 5 and 60 seconds. In extreme circumstances
this step can take up to 15 minutes.

5

  Switch ON the TV.

Try out the buttons you

need for operating it. Try, for

example, if the - CH + and

digit buttons function

properly.

•   If a button does not work

as expected, press and hold that button. Release it

immediately as soon as it works. For more information,

see chapter 2.2.2.

6

  Press the

device

selection button twice to

finish setup.

 •

 

When no button is

pressed for 5 minutes

or more, the remote

control will exit setup mode, automatically saving all

your settings.

Important

If you made a mistake:

•   Press the device selection button twice to exit setup.

The red Setup light

turns off.

•  Restart from the beginning.

Getting

star

ted

English

5 sec.

5 - 60 sec.

5-60 SEC.

2 x