Zenoah EX-BC Manuale Utente
38
9. Maintenance
(EX-BC only)
EX-BC
MA1
MA1
EX-BC
MA2
MA2
EX-BC
MA3
MA3
EX-BC
MA4
MA4
■ REFILLING TRIMMING LINE
1. For replacement line, use a diameter of .095
1. For replacement line, use a diameter of .095
in(2.4mm). The spool is capable for a line upto
27ft(8m)on the 4” head, and 46ft(14m)on the 6”
head. Avoid using a larger line as it may cut
down the trimming performance.
27ft(8m)on the 4” head, and 46ft(14m)on the 6”
head. Avoid using a larger line as it may cut
down the trimming performance.
For safety reasons, do not use
metalreinforced line.
metalreinforced line.
2. Pinch the slotted area on the both sides of the
spool housing to unhook the bottom cap. (MA1)
3. Take out the spool and pull off the old line. Put
one end of new line through the spool holes and
pull it until the length is equal between each part
of the line. (MA2)
pull it until the length is equal between each part
of the line. (MA2)
4. Wind up the line in the correct direction as
indicated on the spool. (MA3)
5. Hook each end of the line in the slot on the edge
of the spool, and then put the ends through the
eyelets on the housing. Make sure that the
spring and the washers are in place. (MA4)
eyelets on the housing. Make sure that the
spring and the washers are in place. (MA4)
6. While holding the spool against the housing, pull
the line ends to release them from the slot.
7. Line up the slot on the bottom cap with the hook
on the housing, press the cap against the
housing until it clicks.
housing until it clicks.
■ GEAR CASE (MA5)
• The reduction gears are lubricated by
• The reduction gears are lubricated by
multipurpose, lithium-based grease in the gear
case. Supply new grease every 25 hours of use
or more often depending on the job condition.
case. Supply new grease every 25 hours of use
or more often depending on the job condition.
• Remove the cutter holders before installing new
grease to arrange for old grease to exit.
WARNING
EX-BC
MA5
MA5