Snapper YZ13331be Manuale Utente

 
4.1  NEUTRAL POSITION ADJUSTMENTS 
The joystick controls the movement and stopping of the 
unit. Move the joystick to the center or neutral position to 
stop mower. IMPORTANT: Always return the joystick 
with hand assistance to the neutral position. If mower 
does not come to a complete stop or has any movement 
when joystick is moved to the neutral position, 
adjustment must be made. It is recommended that these 
adjustments be made by an authorized SNAPPER 
dealer. But, adjust joystick cables as follows after 
removing fenders: 

 
1. If mower tracks to the right, loosen bottom nut 
first on the right cable. Turn top nut clockwise in a 
1/8 increment then retighten lower nut to secure 
cable. Check tracking of mower. Repeat this 
adjustment if necessary. See Figure 4.1. 
2.  If mower tracks to the left, loosen bottom nut first 
on the left cable. Turn top nut clockwise in a 1/8 
increment then retighten lower nut to secure cable. 
Check tracking of mower. Repeat this adjustment if 
necessary. See Figure 4.1. 

 

 

 
 

4.2  ENGINE ADJUSTMENTS & REPAIR 
Refer to the engine owner’s manual for those adjustments 
and/or repairs that can be made by the owner. 
 
4.3  MOWER DECK & COMPONENT ADJUSTMENTS 
The following mower deck and component adjustments 
and repairs can be made by the owner.  However, if 
there is difficulty in achieving these adjustments and 
repairs, it is recommended that these repairs be made by 
an authorized SNAPPER dealer. 
 

4.3.1.  MOWER DRIVE BELT ADJUSTMENT 
The 33” and 38” mower deck drive belts do not 
require any adjustment. If the belt does not drive 
blade properly, replace belt as needed. See Section 
on Belt Replacement. Belt routing shown on this 
page. See Figure 4.2. 

 

 

 

 

FIGURE 4.2