Snapper SPE361 Manuale Utente

 

5.3 HANDLE HEIGHT 

The operator handle can be adjusted for operator 
comfort as follows: 
 
1.  Loosen the upper carriage bolt and nut on both 

sides of handlebar. See Figure 5.4. 

2.  Remove lower carriage bolt and nut on both sides of 

handlebar. 

3.  Raise or lower handlebar to desired height. See 

Figure 5.3. 

4.  Install the carriage bolt and nut in the lower hole in 

handlebar and securely tighten nut.  See Figure 5.4. 

5.  Securely tighten the upper carriage bolt and nut. 
6.  After adjusting the handle height readjust traction 

links as described earlier. Shift rod (Connects the 
ground speed control lever and the transmission) 
will have to be readjusted. 

7.  Readjust traction levers/rods when handle height is 

changed. 

 
 

 

 
 
 
 

 

 

 
1.  Disconnect the hair pin from shift rod that connects 

to the Transmission Shift lever. See Figure 5.5. 

2.  Move the Transmission Shift Lever to the neutral 

position. Move the shift lever, located on the 
transmission, to the neutral position.  

3.  Rotate the shift rod clockwise or counter clockwise 

to allow the upper portion of shift rod to be inserted 
into the ground speed control lever without moving 
the speed control lever or the Transmission Shift 
lever. Reinstall hair pin. See Figure 5.6. 

 

 

 

 

FIGURE 5.6 

UP 

DOWN