Snapper 216517B Manuale Utente

 

2.  Remove driven disc spring from driven disc 
assembly. Loosen connector hex nut. See Figure 4.9. 

 

 

 

 
3.  Slide driven disc assembly over to 1/8” from outside 
edge of drive disc. Maintaining the 1/8” measurement, 
remove any looseness from the linkage.  This can be 
done by holding the transfer rod and applying pressure 
to the left (as viewed from operators position). Then 
retighten the connector hex nut securely. See Figure 
4.10. Move ground speed control to the first speed 
position, then back to the sixth speed position. 
Recheck the 1/8” measurement described previously.  
Reinstall driven disc spring to driven disc assembly. 

 

4.3.4.  Replacing Rubber Driven Disc 
If the rubber is badly chunked or worn it must be 
replaced. Install new Driven Disc as follows: 
1.  Using a small flat blade screwdriver, free the clip 
from the transfer rod. Then remove the transfer rod 
from the clip and the speed control rod. See Figure 
4.11.