Snapper CP214017R2 Manuale Utente

 

 

 
2.6  RECYCLING OPERATION - OPTIONAL 
ACCESSORY 
Recycling operation requires optional accessory. 
 
NOTE: For best recycling results, cut up to a maximum 
of 1/3 of grass blade length and recycle ONLY when 
grass is dry. 
 

1.  Set all wheels in the highest cutting position 
(Notch 6). 
2.  Move engine speed control to “FAST” (Rabbit) 
position. 
3. Move ground speed control to slowest speed 
setting. 
4.  Proceed mowing slowly. If grass is very dense, 
lower each rear wheel latch one notch lower than 
the front wheel latches to improve recycling 
performance. 

 
2.7  INSTALLATION of GRASS CATCHER 

 
Position grass bag between handles. See Figure 
2.8. Install grass catcher by sliding connector over 
flange of adapter. Attach grass bag hooks over 
middle handle cross bar. See Figure 2.9. 
 

 

 

 

 

 
2.8  REMOVING and DUMPING GRASS CATCHER 

1.  Grasp bag connector and bag handle as 

shown. See Figure 2.8. 

2.  First, lift up on bag handle, removing it from the 

mower handle. Then lift up on bag connector 
removing it from the adapter flange. 

3.  Dump bag by pulling bag slider off of Z-Fold at 

rear of bag, opening bag. 

4.  To close bag, fold rear of bag into Z-shape, 

keeping edges aligned. Note: an illustration of 
folding the Z-shape is attached to the bag. 

5.  Grasp the edge of the Z-fold, and while holding 

the slider, pull the Z-fold fully into the slider. 
See Figure 2.10.