Philips 37 Guida Al Software
Upgrade WAS5 Station:
6. Press STANDBY-ON to turn on WAS5 Station
6. Press STANDBY-ON to turn on WAS5 Station
→
Upgrading starts automatically
→
The display shows “Updating firmware, please wait……” .
A progress bar appears
→
Station will reboot itself twice during the upgrading process
→
After about 5 minutes, Station returns to HD mode. The upgrading is
completed
(Note: - Keep your Station turned on during the upgrading.)
(Note: - Keep your Station turned on during the upgrading.)
Helpful hints:
- To check the firmware version, see Preparation: Verifying firmware
version.
- If you have any problem, see
.
__________________________________________________________________
5. Troubleshooting
If the Station’s display shows: "Firmware is damaged, restoring a new copy …"
or "Center is connected, retrieving firmware"
Follow the DON’T below:
a.
DON’T restore Center’s setting
(Don’t select "Menu" → "Setting"
→ "Restore Setting" on Center)
b.
DON’T delete Stations
from Center (Don’t select "Menu" →
"Station Mgnt" → "Delete Station" on Center)
c.
Do NOT change Center’s Wi-Fi setting
Then,
1. If the progress bar is moving on, wait and upgrading will start later on the
1. If the progress bar is moving on, wait and upgrading will start later on the
Station
2. If the progress bar stops moving and/or Station’s display shows "Error Code
xxx", turn off the Station and then turn it on.
3. If Step 2’s problem still exists, check there is no Wi-Fi interference around and
reduce the distance between Center, Station and Wireless router/Access Point
(if applicable)
(if applicable)
__________________________________________________________________