Enterasys 6000 Guida Utente
Introduction to Netlink Frame Relay Access Devices
1-15
Introduction to Menu Operations
The FRX/FRM user interface consists of a series of menus and sub-menus that are
used to configure, control, and monitor a node. To protect the system from unautho-
rized access, menu operations are accessible only after the operator enters a password.
used to configure, control, and monitor a node. To protect the system from unautho-
rized access, menu operations are accessible only after the operator enters a password.
When running outside the menu operations, a display will be similar to the following
figure, and will show the current status of all ports on the node. (This display is
described in detail on page 17-3.)
figure, and will show the current status of all ports on the node. (This display is
described in detail on page 17-3.)
Figure 1-8 Port Status Display
This example shows an FRX6000 display. On an FRX4000 or FRM
display, the
display, the
L
(LP) column will be all
0
s, since the FRX4000 has no RLPs
and FRM has only one.
Node Name
identifies the node under control of the keyboard and screen.
This will generally be a directly attached node, in which case the ID will be the
Node Name
configured in the Node Defaults file (described in Chapter 3).
If an operator takes remote control of another node (described on page 16-2),
Node Name
will become the
Remote Control ID
configured in Node Defaults
on the controlled node. Any configuration or control operations will affect that
node rather than the local one. If the controlled node has a display screen, the
message
node rather than the local one. If the controlled node has a display screen, the
message
Under remote control. Keyboard blocked by id="n"
will be displayed,
where "
n
" is the
Remote Control ID
of the controlling node.
The Ethernet/Token Ring port status will be displayed as
Operational
whether or not a LAN interface has been configured. To determine if the
interface is truly operational, press
interface is truly operational, press
[E]
, then
[G]
from the Main Menu to
display LAN Card statistics. The actual
Hardware Status
of the interface
will be displayed on that screen.
N ode N ame= node_xyz
Port S tatus Disp lay (Page 1)
L P Type
PPS C onn#
State
L
P Type PPS
C onn# State
0
0
FR L
62
4
Op erational
0
1
SNA
127
12
Operational
0
2
FR L
112
7
Op erational 0
3
SNA
60
6
Operational
0
4
SNA 110
3
Op erational
0
5
X25
87
5
Operational
1
0
ASY
0
0
Lin k_disab le
1
1
X25
88
4
Operational
0
Eth
0
0
Op erational
F1: Login