Sanyo PLC-WXU300 Guida Utente

Unplug the AC power cord before cleaning.

Gently wipe the projection lens with a cleaning cloth that

contains a small amount of non-abrasive camera lens

cleaner, or use a lens cleaning paper or commercially

available air blower to clean the lens.

Avoid using an excessive amount of cleaner. Abrasive

cleaners, solvents, or other harsh chemicals might scratch

the surface of the lens.

Unplug the AC power cord before cleaning.

Gently wipe the projector body with a soft dry cleaning cloth.

When the cabinet is heavily soiled, use a small amount of

mild detergent and finish with a soft dry cleaning cloth. Avoid

using an excessive amount of cleaner. Abrasive cleaners,

solvents, or other harsh chemicals might scratch the surface

of the cabinet.

When the projector is not in use, put the projector in

an appropriate carrying case to protect it from dust and

scratches.

When  moving  this  projector  or  while  not  using  it  over  an

extended period of time, replace the lens cap.

Attach the lens cap according to the following procedures.

Thread the string through the hole on the lens cap and

then tie a knot in the string to secure it in place.

To pass the other end of the string into the hole on the

top of the projector and pull at it.

Do not use any flammable solvents or air sprays on the

projector and in its vicinity. The explosion or fire hazard may

occur even after the AC power cord is unplugged because

the temperature inside the projector is extremely high due to

the lamps. In addition, there is a risk that the internal parts

may be damaged not only by the flammable air spray but

also by the cold air.