Alcatel-Lucent 6850-48 Guida Di Rete

Using Switch Logging

Switch Logging Commands Overview

OmniSwitch AOS Release 6 Network Configuration Guide

page 46-9

To remove the switch logging severity level, enter the no

command, including the 

application ID and severity level values. The following is a typical example:

-> no swlog appid 75 level 5

Or, alternatively, as:

-> no swlog appid system level warning 

No confirmation message will appear on the screen.

command allows you to send the switch logging information to your 

console, to the switch’s flash memory, or to a specified IP or IPv6 address(es).

To enable the switch logging output to the console, enter the following command:

-> swlog output console

To disable the switch logging output to the console, enter the following command:

-> no swlog output console

No confirmation message will appear on the console screen for either command.

To enable the switch logging output to flash memory, enter the following:

-> swlog output flash

To disable the switch logging output to flash memory, enter the following command:

-> no swlog output flash

No confirmation message will appear on the screen for either command.

To specify a particular IP address destination (e.g., a server) for switch logging output, enter the

 socket ipaddr command, specifying the target IP address to which output 

will be sent. For example, if the target IP address is 168.23.9.100, you would enter:

-> swlog output socket ipaddr 168.23.9.100

No confirmation message will appear on the screen.

Note. You can also send syslog files to multiple hosts (maximum of four).