Alcatel-Lucent 6850-48 Guida Di Rete
Spanning Tree Bridge Parameter Defaults
Configuring Spanning Tree Parameters
page 13-4
OmniSwitch AOS Release 6 Network Configuration Guide
September 2009
Spanning Tree Bridge Parameter Defaults
Spanning Tree Port Parameter Defaults
Parameter Description
Command
Default
Spanning Tree operating mode
1x1 (a separate Spanning Tree
instance for each VLAN)
instance for each VLAN)
PVST+ status
Disabled
Spanning Tree protocol
RSTP (802.1w)
BPDU switching status
Disabled
Priority value for the Spanning
Tree instance
Tree instance
32768
Hello time interval between each
BPDU transmission
BPDU transmission
2 seconds
Maximum aging time allowed
for Spanning Tree information
learned from the network
for Spanning Tree information
learned from the network
20 seconds
Spanning Tree port state transi-
tion time
tion time
15 seconds
Automatic VLAN Containment
Disabled
Parameter Description
Command
Default
Spanning Tree port administrative state
Enabled
Spanning Tree port priority value
7
Spanning Tree port path cost
0 (cost is based on port speed)
Path cost mode
Auto (16-bit in 1x1 mode and
STP or RSTP flat mode, 32-bit
in MSTP flat mode)
STP or RSTP flat mode, 32-bit
in MSTP flat mode)
Port state management mode
Dynamic (Spanning Tree Algo-
rithm determines port state)
rithm determines port state)
Type of port connection
auto point to point
Type of BPDU to be used on a port when
1X1 PVST+ mode is enabled
1X1 PVST+ mode is enabled
auto (IEEE BPDUs are used
until a PVST+ BPDU is
detected)
until a PVST+ BPDU is
detected)