Alcatel-Lucent 6850-48 Guida Di Rete
Configuring Dynamic Link Aggregation
Configuring Dynamic Link Aggregate Groups
OmniSwitch AOS Release 6 Network Configuration Guide
September 2009
page 23-13
As an option, you can use the ethernet, fastethernet, and gigaethernet keywords before the slot and port
number to document the interface type or make the command look consistent with early-generation
Alcatel-Lucent CLI syntax. For example, to configure an actor administrative key of 10 and to document
that the port is a 10-Mbps Ethernet port to slot 4 port 1, enter:
number to document the interface type or make the command look consistent with early-generation
Alcatel-Lucent CLI syntax. For example, to configure an actor administrative key of 10 and to document
that the port is a 10-Mbps Ethernet port to slot 4 port 1, enter:
-> lacp agg ethernet 4/1 actor admin key 10
Note. The ethernet, fastethernet, and gigaethernet keywords do not modify a port’s configuration. See
for information on configuring Ethernet ports.
Removing Ports from a Dynamic Aggregate Group
To remove a port from a dynamic aggregate group, use the no form of the
command by entering lacp agg no followed by the slot number, a slash (/), and the port number.
For example, to remove port 4 in slot 4 from any dynamic aggregate group you would enter:
-> lacp agg no 4/4
Ports must be deleted in the reverse order in which they were configured. For example, if port 9 through
16 were configured to join dynamic aggregate group 2 you must first delete port 16, then port 15, and so
forth. The following is an example of how to delete ports in the proper sequence from the console:
16 were configured to join dynamic aggregate group 2 you must first delete port 16, then port 15, and so
forth. The following is an example of how to delete ports in the proper sequence from the console:
-> lacp agg no 4/24
-> lacp agg no 4/23
-> lacp agg no 4/22