Alcatel-Lucent 6850-48 Guida Di Rete
Displaying Dynamic Link Aggregation Configuration and Statistics
Configuring Dynamic Link Aggregation
page 23-32
OmniSwitch AOS Release 6 Network Configuration Guide
September 2009
10 Repeat steps 1 through 9 on Switch C. All the commands would be the same except you would substi-
tute the appropriate port numbers.
tute the appropriate port numbers.
Note. If you do not use the qos apply command any QoS policies you configured will be lost on the next
switch reboot.
switch reboot.
Displaying Dynamic Link Aggregation
Configuration and Statistics
You can use Command Line Interface (CLI) show commands to display the current configuration and
statistics of link aggregation. These commands include the following:
statistics of link aggregation. These commands include the following:
When you use the show linkagg command without specifying the link aggregation group number and
when you use the show linkagg port command without specifying the slot and port number, these
commands provide a “global” view of switch-wide link aggregate group and link aggregate port informa-
tion, respectively.
when you use the show linkagg port command without specifying the slot and port number, these
commands provide a “global” view of switch-wide link aggregate group and link aggregate port informa-
tion, respectively.
For example, to display global statistics on all link aggregate groups (both dynamic and static) you would
enter:
enter:
-> show linkagg
A screen similar to the following would be displayed:
Number Aggregate SNMP Id Size Admin State Oper State Att/Sel Ports
-------+----------+--------+----+-------------+-------------+-------------
1
Static
40000001
8
ENABLED
UP
2
2
2
Dynamic
40000002
4
ENABLED
DOWN
0
0
3
Dynamic
40000003
8
ENABLED
DOWN
0
2
4
Static
40000005
2
DISABLED
DOWN
0
0
When you use the show linkagg command with the link aggregation group number and when you use the
show linkagg port command with the slot and port number, these commands provide detailed views of
the link aggregate group and port information, respectively. These detailed views provide excellent tools
for diagnosing and troubleshooting problems.
show linkagg port command with the slot and port number, these commands provide detailed views of
the link aggregate group and port information, respectively. These detailed views provide excellent tools
for diagnosing and troubleshooting problems.
For example, to display detailed statistics for port 1 in slot 2 that is attached to dynamic link aggregate
group 1 you would enter:
group 1 you would enter:
-> show linkagg port 2/1
Displays information on link aggregation groups.
Displays information on link aggregation ports.