Alcatel-Lucent 6850-48 Guida Di Rete
VRF Interaction With Other Features
Configuring Multiple VRF
page 25-10
OmniSwitch AOS Release 6 Network Configuration Guide
September 2009
AAA RADIUS Servers
• AAA RADIUS servers can be configured on any VRF instance including the default VRF instance.
However, all of the RADIUS servers must reside on the same VRF instance.
• The VRF instance that the RADIUS server is configured on becomes the “management” VRF instance
and can perform authentication for any of the following services:
• If the VRF instance that the RADIUS servers reside on is deleted or disabled, access to the RADIUS
servers will be disabled as well.
BGPv4
• Each BGPv4 routing instance requires configuration of an Autonomous System number, router ID
number, and primary IP address that is explicit to the associated VRF instance.
• BGP neighbors defined for a specific VRF instance and address family (IPv4 and IPv6) will peer with
neighbors accessible through interfaces associated with the same VRF instance.
IP-IP and GRE Tunnels
Tunnel endpoint addresses always exist in the default VRF instance regardless of the instance in which the
tunnel interface is configured.
tunnel interface is configured.
Management Applications (Telnet and SSH)
• Telnet and SSH (ssh, sftp, and scp) sessions “to” the switch are now VRF aware. Client support for
these utilities is supported only in the default VRF instance.
• A maximum of 4 combined Telnet sessions are allowed simultaneously across all VRFs on the switch.
• A maximum of 8 combined SSH sessions are allowed simultaneously across all VRFs on the switch
Quality of Service (QoS)
• The Auto-NMS feature (non-VRF aware) recognizes all of the IP interfaces configured in the default
VRF instance. The first eight of these interfaces are prioritized by Auto-NMS to ensure switch manage-
ability in the event of a DoS attack.
ability in the event of a DoS attack.
• Policy Based Routing, as indicated in the table above, is a default VRF application. The functionality
of this feature remains the same as in releases prior to the implementation of Multiple VRF instances.
VRF Policies
• A VRF policy condition parameter is available to specify a VRF name to which the policy condition
applies. This parameter can also specify the default VRF, and a no form of the command exists to
remove a VRF condition parameter. For example:
remove a VRF condition parameter. For example:
Console
Telnet
FTP
SSH (ssh, sftp, and scp)
Telnet
FTP
SSH (ssh, sftp, and scp)
HTTP
SNMP
802.1X
MAC-based authentication
SNMP
802.1X
MAC-based authentication