Alcatel-Lucent 6850-48 Guida Di Rete
Configuring 802.1X
Quick Steps for Configuring 802.1X
OmniSwitch AOS Release 6 Network Configuration Guide
September 2009
page 37-3
Quick Steps for Configuring 802.1X
1 Configure the port as a mobile port and an 802.1X port using the following vlan port commands:
-> vlan port mobile 3/1
-> vlan port 3/1 802.1x enable
The port is set up automatically with 802.1X defaults. See
for informa-
tion about the defaults. For more information about vlan port commands, see
2 Configure the RADIUS server to be used for port authentication:
-> aaa radius-server rad1 host 10.10.2.1 timeout 25
for more information about configuring RADIUS
authentication servers for 802.1X authentication.
Note. If 802.1X users authenticate into an authenticated VLAN, the VLAN must be configured with the
command. For information about configuring VLANs with authentication, see
3 Associate the RADIUS server (or servers) with authentication for 802.1X ports:
-> aaa authentication 802.1x rad1
4 (Optional) Associate the server (or servers) to be used for accounting (logging) 802.1X sessions. For
example:
example:
-> aaa accounting 802.1x rad2 ldap3 local
5 (Optional) Configure port-access control parameters for the 802.1X port using the
command:
-> 802.1x 3/1 quiet-period 45 max-req 3
6 (Optional) Configure the number of times supplicant devices are polled for identification using the
command:
-> 802.1x 3/1 supp-polling retry 10
Note. Verify the 802.1X port configuration using the
-> show 802.1x 1/13
802.1x configuration for slot 1 port 13:
direction = both,
operational directions = both,
port-control = auto,
quiet-period (seconds) = 60,
tx-period (seconds) = 30,
supp-timeout (seconds) = 30,
server-timeout (seconds) = 30,
max-req = 2,
re-authperiod (seconds) = 3600,
reauthentication = no
Supplicant polling retry count = 2