Alcatel-Lucent 6850-48 Guida Di Rete

Configuring QoS

Creating Policies

OmniSwitch AOS Release 6 Network Configuration Guide

page 40-33

This section describes how to create policy conditions in general. Creating policy conditions for particular 
types of network situations is described later in this chapter.

Note. Policy condition configuration is not active until the qos apply command is entered. See 

To create or modify a policy condition, use the policy condition command with the keyword for the type 
of traffic you want to classify, for example, an IP address or group of IP addresses. In this example, a 
condition (c3) is created for classifying traffic from source IP address 10.10.2.1:

-> policy condition c3 source ip 10.10.2.1

There are many options for configuring a condition, depending on how you want the switch to classify 
traffic for this policy. An overview of the options is given here. Later sections of this chapter describe how 
to use the options in particular network situations.

Note. The group options in this command refer to groups of addresses, services, or ports that you config-
ure separately through policy group commands. Rather than create a separate condition for each address, 
service, or port, use groups and attach the group to a single condition. See 

 for more information about setting up groups.

More than one condition parameter may be specified. Some condition parameters are mutually exclusive. 
For supported combinations of condition parameters, see 

The condition will not be active on the switch until you enter the qos apply command.