Alcatel-Lucent 6850-48 Guida Di Rete

Configuring QoS

Using Condition Groups in Policies

OmniSwitch AOS Release 6 Network Configuration Guide

page 40-47

Note. MAC group configuration is not active until the qos apply command is entered.

To delete addresses from a MAC group, use no and the relevant address(es):

-> policy mac group macgrp2 no 08:00:20:00:00:00

This command specifies that MAC address 08:00:20:00:00:00 will be deleted from macgrp2 at the next 
qos apply.

To delete a MAC group, use the no form of the policy mac group command with the relevant MAC 
group name. The group must not be associated with any policy condition. For example:

-> no policy mac group macgrp2

MAC group macgrp2 will be deleted at the next qos apply. If macgrp2 is associated with a policy condi-
tion, an error message will display instead:

ERROR: macgrp2 is being used by condition 'cond3'

In this case, remove the MAC group from the condition first; then enter the no policy mac group 
command. For example:

-> policy condition cond3 no source mac group

-> no policy mac group macgrp2

The policy condition command removes the MAC group from the condition. See 

 for more information about configuring policy conditions. The MAC group will be 

deleted at the next qos apply.

Port groups are made up of slot and port number combinations. Note that there are many built-in port 
groups, one for each slot on the switch. Built-in port groups are subdivided by slice. The built in groups 
are named by slot (Slot01, Slot02, etc.). To view the built-in groups, use the 

command.

To create a port group, use the policy port group command. For example:

-> policy port group techpubs 2/1 3/1 3/2 3/3

The port group may then be associated with a condition through the policy condition command. Note that 
the policy condition specifies whether the group should be used for source or destination. For example:

-> policy condition cond4 source port group techpubs

This command creates a condition called cond4 that may be used in a policy rule to classify traffic by 
source port number. The port numbers are specified in the port group. For more information about config-
uring conditions, see 

.

Note. Port group configuration is not active until the qos apply command is entered.

To delete ports from a port group, use no and the relevant port number(s).

-> policy port group techpubs no 2/1