Alcatel-Lucent 6850-48 Guida Di Rete

Configuring IPMSv6 on a Switch

Configuring IP Multicast Switching

page 42-26

OmniSwitch AOS Release 6 Network Configuration Guide

To restore the MLD version to Version 1 (MLDv1) on the system if no VLAN is specified, use the 

 command by entering:

-> ipv6 multicast version 0

Or, as an alternative, enter:

-> ipv6 multicast version

To restore the MLD version to Version 1.

You can also restore the MLD version to Version 1 (MLDv1) on the specified VLAN by entering:

-> ipv6 multicast vlan 2 version 0

Or, as an alternative, enter:

-> ipv6 multicast vlan 2 version

To restore the MLD version to Version 1.

MLD static neighbor ports receive all multicast streams on the designated VLAN and also receive MLD 
reports for the VLAN. The following subsections describe how to configure and remove a static neighbor 
port by using the 

command.

You can configure a port as an MLD static neighbor port by entering 

followed by vlan, a space, VLAN number (which must be between 0 and 4095), a space, followed by 
port, a space, the slot number of the port, a slash (/), and the port number.

For example, to configure port 10 in slot 4 with designated VLAN 2 as an MLD static neighbor you would 
enter:

-> ipv6 multicast static-neighbor vlan 2 port 4/10

You can also configure a link aggregation group as an MLD static neighbor port by entering 
ipv6 multicast static-neighbor followed by vlan, a space, VLAN number (which must be between 0 and 
4095), a space, followed by port, a space, and the link aggregation group number.

For example, to configure link aggregation group 7 with designated VLAN 2 as a static neighbor you 
would enter:

-> ipv6 multicast static-neighbor vlan 2 port 7